Octolapse cant set it up right,i'm stuck - Plugins - OctoPrint Community Forum

Hello guys, I was wondering if someone could help me to setup the octolapse. My printer is an creality cr6se with raspberry pi4b 4gb and a logitech 922. The slicer that i am using is cura 5.1.1 I am spending a few evenings now and i cant setup octolapse the right way. Now i get the error gcode priming was not detected. I watched several tutorials but they use old version of octoprint or plugin. So is there someone who have an cr6se profile that i can load in my octoprint? here is

OctoPrint

Can't install octolapse due to error from building wheel - Octolapse - OctoPrint Community Forum

OctoPrint

Octolapse on windows Camera issues - Octolapse - OctoPrint Community Forum

Wyze Cam V2 Support? - Webcams - OctoPrint Community Forum

OctoPrint

Octolaps wont start - Octolapse - OctoPrint Community Forum

Settings Load Error - Octolapse - OctoPrint Community Forum

Cannot install Octolapse on Python 3.10.6 · Issue #888 · FormerLurker/ Octolapse · GitHub

The Best Octolapse/OctoPrint Time-Lapse Settings