Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

Can someone explain why I am getting an extra retraction command right before my skirt starts? When I print, the filament doesn't print for sometime because of the extra retraction. I have tried it in both 3.4.1 and 3.5. Maybe I have a setting that is checked or set wrong. Below is my gcode from

Unnecessary start points ruining print, please help - UltiMaker

how to make this print faster? : r/ender3

3D Printing Slicer Software - How to Choose the Best

Retraction speed cannot be increased above 50mm/s with the SV-01

Gcode varies retraction value? - UltiMaker Cura - UltiMaker

First layers K8400 - Software (Repetier & Cura) - Whadda forum

Unnecessary retractions with Combing mode Off · Issue #4308

Cura retraction settings explained

Cura Alpha 🎄 Tree Support Spotlight 🎄 · Ultimaker Cura

Scalable extra prime - UltiMaker Cura - UltiMaker Community of 3D

Tree supports : retractions and travel issue · Issue #15479

too much retraction at beginning - Improve your 3D prints

Using the Monoprice Voxel (FlashForge Adventure 3) With Ultimaker

Stringing Nightmares: How Cura's Travel Settings Can Save 3D

Cura 2.7 strange retract behavior - UltiMaker Cura - UltiMaker